System ubuntu 14.04 on virtual machine. Today i compiled new image udoo ubuntu trusty 3.14.28 but not boot on my udoo quad.
U-Boot SPL 2015.10-armbian (Jan 02 2016 - 11:41:27)
U-Boot 2015.10-armbian (Jan 02 2016 - 11:41:27 +0100)
CPU: Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: UDOO Quad
DRAM: 1 GiB
MMC: FSL_SDHC: 0
*** Warning - bad CRC, using default environment
No panel detected: default to HDMI
Display: HDMI (1024x768)
In: serial
Out: serial
Err: serial
Net: using phy at 6
FEC [PRIME]
Hit any key to stop autoboot: 0
switch to partitions #0, OK
mmc0 is current device
Scanning mmc
Found U-Boot script /boot.scr
** File not found /boot.scr **
** Unrecognized filesystem type **
Found U-Boot script /boot/boot.scr
590 bytes read in 160 ms (2.9 KiB/s)
Running bootscript from mmc ...
## Executing script at 12000000
** File not found /boot/dtb/imx6q-udoo-hdmi.dtb **
** Unrecognized filesystem type **
6681024 bytes read in 483 ms (13.2 MiB/s)
Kernel image @ 0x12000000 [ 0x000000 - 0x65f1c0 ]
ERROR: Did not find a cmdline Flattened Device Tree
Could not find a valid device tree
Device Tree: dts/imx6q-udoo-hdmi.dtb
** Unrecognized filesystem type **
Booting from net ...
BOOTP broadcast 1
BOOTP broadcast 2
BOOTP broadcast 3
DHCP client bound to address 192.168.0.101 (3016 ms)
Using FEC device
TFTP from server 0.0.0.0; our IP address is 192.168.0.101; sending through gateway 192.168.0.1
Filename 'zImage'.
Load address: 0x12000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
BOOTP broadcast 1
BOOTP broadcast 2
BOOTP broadcast 3
DHCP client bound to address 192.168.0.101 (3015 ms)
Using FEC device
TFTP from server 0.0.0.0; our IP address is 192.168.0.101; sending through gateway 192.168.0.1
Filename 'dts/imx6q-udoo-hdmi.dtb'.
Load address: 0x18000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
Bad Linux ARM zImage magic!