Hello,
I want to boot Hummingboard Edge with Armbian (Jessie - kernel 3.14.54) , but I'm experiencing problems during the booting procedure.
Bootloader is searching for some files then it gives up. I have copied two files (imx6q-hummingboard2.dtb to imx6q-hummingboard.dtb) to /boot/dtb/ folder. It looks like it starts with the kernel, but it never loads completely. Below are the steps:
U-Boot SPL 2013.10-rc4-sun7i (Oct 11 2015 - 20:45:45)
Boot Device: SD1
spl: error reading image u-boot.img, err - -1
Load image from RAW...
U-Boot 2013.10-rc4-sun7i (Oct 11 2015 - 20:45:45)
CPU: Freescale i.MX6Q rev1.5 at 792 MHz
Reset cause: POR
Board: MX6-HummingBoard2
DRAM: 2 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Hit any key to stop autoboot: 0
mmc0 is current device
** File not found /boot.scr **
** File not found /uEnv.txt **
** File not found /zImage **
** File not found /uImage **
437 bytes read in 130 ms (2.9 KiB/s)
Running bootscript from mmc ...
## Executing script at 10800000
40257 bytes read in 421 ms (92.8 KiB/s)
6015384 bytes read in 584 ms (9.8 MiB/s)
Kernel image @ 0x12000000 [ 0x000000 - 0x5bc998 ]
## Flattened Device Tree blob at 18000000
Booting using the fdt blob at 0x18000000
Using Device Tree in place at 18000000, end 1800cd40
Starting kernel ...
I would be happy, if you can give me some pointers on how to solve this problem.
With Solidrun linux port it works normally.
Thank you.
