• Content Count

  • Joined

  • Last visited

  1. xefil

    [ArmbianBananaPi] - script.bin missing

    THANKS! I'll give it a try and let you know Simon
  2. xefil

    [ArmbianBananaPi] - script.bin missing

    Good morning, That's a great point to start with, and as always, first rule, RTFM, you're absolutely right. I've started reading it and it's a little complicated. The part that I think it's referred on what I need is: Due I'll need to connect on this board two radio (one NRF24L01+ and one RFM69), I fear to make some damages, so I ask here. I would start with one radio first, the RFM69. But here comes the first question it's not totally clear for me: 1. Is the BananaPi able to have two radio connected on the GPIO? Seems yes if the above doc speeks about SPI 0 - 1 - 2 all with required MOSI, MISO, SCK, CS.... But I've read somewhere for RPi the following: 2. I'ts valid for BananaPi as well? BTW then, let's start with the first radio assuming I can start with bus0. The overlay should look like: overlays=spi-spidev param_spidev_spi_bus=0 That should create a "/dev/spidev***" device. This should give me those connections GPIO available: MOSI: PI12 -> CON3-PORT19 MISO: PI13 -> CON3-PORT21 SCK: PI11 -> CON3-PORT23 CS: PI10 -> CON3-PORT24 Then I'm missing the power 3.3v (CON3-PORT01), ground (CON3-PORT06) and IRQ, which should be ok any normal PIN (i.e. CON3-PORT22). Until here makes it sense?? Sorry, but as written above I fear I could make some mistrakes and damage the devices. Assuming the above works, how can then I add a second spidev? This is something I cannot understand from the documentation. Many thanks, Simon
  3. xefil

    [ArmbianBananaPi] - script.bin missing

    Hello, Sorry but nobody can give me some hints? Thanks, Simon
  4. Hello to all! I'm using Armbian on my BananaPi board. I've the following version: ARMBIAN 5.38 stable Debian GNU/Linux 9 (stretch) 4.14.15-sunxi BOARD=bananapi BOARD_NAME="Banana Pi" VERSION=5.35 LINUXFAMILY=sunxi BRANCH=next ARCH=arm IMAGE_TYPE=user-built BOARD_TYPE=conf INITRD_ARCH=arm KERNEL_IMAGE_TYPE=zImage I need to follow these instructions to wire a radio on the board: https://www.mysensors.org/build/orange But I cannot find the script.bin file. Why? I can remember the file was here on old releases. Any help or suggestion? Thanks, Simon