mgs2 Posted August 28, 2019 Posted August 28, 2019 Good Day everyone! I have 4 of these Kata Boxes lying around the house, and due to the poor firmware of which was never updated, I was hoping to have Armbian installed to that I could place these near my DAC's to become essentially DLNA devices (Of which I hope will be painless). However, in trying to boot armbian, I have no luck whatsoever. In Libreelec, I am able to boot fine from the SD Card no problem, and since I have an opportunity to SSH, I wanted to know the device tree it was using by running the command "cat /proc/device-tree/le-dt-id," the result of was "gxbb_p200 LibreELEC:~ #." With that information, I've used the same dtb located in the dtb folder of the Armbian build I am using, and nothing happens. The build I'm trying to install is Armbian_5.94_Aml-g12_Ubuntu_bionic_next_5.3.0-rc6-next-20190827_desktop Thank you very much!
Recommended Posts