Florin Posted September 3, 2020 Posted September 3, 2020 I have a TX5 PRO that i flashed with Armbian a while back. Yesterday i decided to upgrade to the latest focal image from this forum (was running an RC version of focal). Booting into the image worked fine, and flashing it to emmc didn't give any errors. However, now the board will not boot. Not sure if i used the 'shutdown' or 'reboot' command, but after installation finished i intended to boot from emmc, but it didn't boot at all. The light stays red, but i recall the light being blue when powered on, so it looks like it is in sleep mode. Power cycling the device does not work, and i can't find the remote (might have been thrown away). Is there any way i can force it to boot up? I've tried with the SD card inside, but still nothing. I've attached a picture with the board, does anyone notice any debugging pads that might help with booting it up?
Recommended Posts