DHCP issue on Armbian_22.08.1_Orangepi3_jammy / 5.15.63

[Sylva1n]

Hello,

 

on a fresh install (Armbian_22.08.1_Orangepi3_jammy_current_5.15.63), the ethernet eth0 interface doesn't retrieve any IP.

 

Quote

root@orangepi3:~# ip a

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000

link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

inet 127.0.0.1/8 scope host lo

valid_lft forever preferred_lft forever

inet6 ::1/128 scope host

valid_lft forever preferred_lft forever

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000

link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff

inet6 fe80::7bd3:dc4e:7cef:fb02/64 scope link noprefixroute

valid_lft forever preferred_lft forever

3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000

link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff

 

Here comes the kernel ethernet related messages:

 

Quote

dmesg -c

[ 28.317964] phy_rtl8211e_led_fixup in

[ 28.319733] dwmac-sun8i 5020000.ethernet eth0: PHY [stmmac-0:01] driver [RTL8211E Gigabit Ethernet] (irq=POLL)

[ 28.320275] dwmac-sun8i 5020000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0

[ 28.320770] dwmac-sun8i 5020000.ethernet eth0: No Safety Features support found

[ 28.320779] dwmac-sun8i 5020000.ethernet eth0: No MAC Management Counters available

[ 28.320786] dwmac-sun8i 5020000.ethernet eth0: PTP not supported by HW

[ 28.321144] dwmac-sun8i 5020000.ethernet eth0: configuring for phy/rgmii-id link mode

[ 31.394770] dwmac-sun8i 5020000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx

[ 31.394820] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

 

After that, I have launched a dhclient command that took several minutes to stop. Then, an APIPA address is attributed to eth0 nterface.

 

Quote

root@orangepi3:~# ip a

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000

link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

inet 127.0.0.1/8 scope host lo

valid_lft forever preferred_lft forever

inet6 ::1/128 scope host

valid_lft forever preferred_lft forever

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000

link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff

inet 169.254.9.46/16 brd 169.254.255.255 scope link eth0:avahi

valid_lft forever preferred_lft forever

3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000

link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff

inet 169.254.12.106/16 brd 169.254.255.255 scope link wlan0:avahi

valid_lft forever preferred_lft forever

 

So I have launched armbian-config to set the eth0 to static. And it worked.

 

Quote

root@orangepi3:~# ip a

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000

link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

inet 127.0.0.1/8 scope host lo

valid_lft forever preferred_lft forever

inet6 ::1/128 scope host

valid_lft forever preferred_lft forever

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000

link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff

inet 192.168.123.111/24 brd 192.168.123.255 scope global noprefixroute eth0

valid_lft forever preferred_lft forever

3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000

link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff

inet 169.254.12.106/16 brd 169.254.255.255 scope link wlan0:avahi

valid_lft forever preferred_lft forever

 

But how to make DHCP works?

 

Thank you

 

 

PS all others devices on my network can retrieve an IP by DHCP. I also tried others OS on my Orange Pi 3 boards and they grab an IP. The issue comes from Armbian.