Jump to content

Init GPIO with DTB overlay


ARM_Bruzzler
Go to solution Solved by ARM_Bruzzler,

Recommended Posts

Hello,

I'm using a BPI M2 Zero (with H3 Chip) to control two relays on CON2-P05 / PA11 and CON2-P03 / PA12.

During the boot process there is a high level present at the pins, which is driving the relays.

Is there a way to create a DTB overlay to drive the pins to a low level during boot.

My userspace application uses  libgpiod to control the pins.

 

I'm familiar with compiling and activating overlays, i would just need help to write the correct .dts file.

 

Thank you very much in advance

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines