• Content Count

  • Joined

  • Last visited

  1. I downloaded it from
  2. I purchased a V7 version of ebin But after updating uboot, the reboot is still in stock uboot. Marvell>> bubt flash-image-1g-1cs-1000_800.bin spi usb Burning U-BOOT image "flash-image-1g-1cs-1000_800.bin" from "usb" to "spi" USB0: Register 2000104 NbrPorts 2 Starting the controller USB XHCI 1.00 USB1: USB EHCI 1.00 scanning bus 0 for devices... 1 USB Device(s) found scanning bus 1 for devices... 2 USB Device(s) found reading flash-image-1g-1cs-1000_800.bin Image checksum...OK! SF: Detected mx25u3235f with page size 256 Bytes, erase size 64 KiB, total 4 MiB 262144 bytes written, 593344 bytes skipped in 2.65s, speed 424017 B/s Done! Marvell>> TIM-1.0 TIM-1.0 TIM-1.0 WTMI-armada-17.10.5-bb8f823 WTMI: system early-init SVC REV: 4, CPU VDD voltage: 1.120V Fill memory before self refresh...done Now in Self-refresh Mode Exited self-refresh ... Self refresh Pass. DDR self test mode test done!! Vref read training =================== Final vdac_value 0x00000020 Vref write training =================== Final vref_value 0x0000001F DLL TUNING ============== DLL 0xc0001050[21:16]: [8,35,1e] DLL 0xc0001050[29:24]: [8,2b,19] DLL 0xc0001054[21:16]: [b,31,1e] DLL 0xc0001054[29:24]: [e,30,1f] DLL 0xc0001074[21:16]: [0,3f,1f] DLL 0xc0001074NOTICE: Booting Trusted Firmware NOTICE: BL1: v1.3(release):armada-17.10.3:39a62a1 NOTICE: BL1: Built : 15:40:57, Jun 1 2NOTICE: BL2: v1.3(release):armada-17.10.3:39a62a1 NOTICE: BL2: Built : 15:40:59, Jun 1 201NOTICE: BL31: v1.3(release):armada-17.10.3:39a62a1 NOTICE: BL31: U-Boot 2017.03-armada-17.10.2-g14aeedc (Jun 01 2018 - 15:39:10 +0800) Model: Marvell Armada 3720 Community Board ESPRESSOBin CPU @ 1000 [MHz] L2 @ 800 [MHz] TClock @ 200 [MHz] DDR @ 800 [MHz] DRAM: 1 GiB U-Boot DT blob at : 000000003f7161b8 Comphy-0: USB3 5 Gbps Comphy-1: PEX0 2.5 Gbps