I purchased a V7 version of ebin
But after updating uboot, the reboot is still in stock uboot.
Marvell>> bubt flash-image-1g-1cs-1000_800.bin spi usb
Burning U-BOOT image "flash-image-1g-1cs-1000_800.bin" from "usb" to "spi"
USB0: Register 2000104 NbrPorts 2
Starting the controller
USB XHCI 1.00
USB1: USB EHCI 1.00
scanning bus 0 for devices... 1 USB Device(s) found
scanning bus 1 for devices... 2 USB Device(s) found
reading flash-image-1g-1cs-1000_800.bin
Image checksum...OK!
SF: Detected mx25u3235f with page size 256 Bytes, erase size 64 KiB, total 4 MiB
262144 bytes written, 593344 bytes skipped in 2.65s, speed 424017 B/s
Done!
Marvell>> TIM-1.0
TIM-1.0
TIM-1.0
WTMI-armada-17.10.5-bb8f823
WTMI: system early-init
SVC REV: 4, CPU VDD voltage: 1.120V
Fill memory before self refresh...done
Now in Self-refresh Mode
Exited self-refresh ...
Self refresh Pass.
DDR self test mode test done!!
Vref read training
===================
Final vdac_value 0x00000020
Vref write training
===================
Final vref_value 0x0000001F
DLL TUNING
==============
DLL 0xc0001050[21:16]: [8,35,1e]
DLL 0xc0001050[29:24]: [8,2b,19]
DLL 0xc0001054[21:16]: [b,31,1e]
DLL 0xc0001054[29:24]: [e,30,1f]
DLL 0xc0001074[21:16]: [0,3f,1f]
DLL 0xc0001074NOTICE: Booting Trusted Firmware
NOTICE: BL1: v1.3(release):armada-17.10.3:39a62a1
NOTICE: BL1: Built : 15:40:57, Jun 1 2NOTICE: BL2: v1.3(release):armada-17.10.3:39a62a1
NOTICE: BL2: Built : 15:40:59, Jun 1 201NOTICE: BL31: v1.3(release):armada-17.10.3:39a62a1
NOTICE: BL31:
U-Boot 2017.03-armada-17.10.2-g14aeedc (Jun 01 2018 - 15:39:10 +0800)
Model: Marvell Armada 3720 Community Board ESPRESSOBin
CPU @ 1000 [MHz]
L2 @ 800 [MHz]
TClock @ 200 [MHz]
DDR @ 800 [MHz]
DRAM: 1 GiB
U-Boot DT blob at : 000000003f7161b8
Comphy-0: USB3 5 Gbps
Comphy-1: PEX0 2.5 Gbps