JonSmith

That is correct yes, once the system boots into Armbian the disk is accessible without issue. I've also managed to enable the built-in SATA port by writing the GPIO registers from u-boot, which is also detected correctly in u-boot (that's a JMicron 2329). I'll make a follow-up post about that.

Hi all, I have a Tronsmart Vega S95 Telos box that I am running armbian 5.76 using an SD card. This works fine, however I would like to boot from a USB to SATA converter instead. It is using a JMicron jms578 which works once Linux has booted however attempting to probe USB devices it prints an error. Is there any way I can make my drive work? I am using the stock Amlogic U-boot, version information also printed below. gxb_p200_v1#usb reset board_usb_stop cfg: 0 (Re)start USB... USB0: dwc_usb driver version: 2.94 6-June-2012 USB (0) peri reg base: c0000000 USB (0) use clock source: XTAL input, div: 1 USB (0) base addr: 0xc9000000 Force id mode: Host dwc_otg: Highspeed device found ! scanning bus 0 for devices... dwc_otg: submit_control_msg: control data phase error (ret = -1) usb_new_device: Cannot read configuration, skipping device 152d:0578 1 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found gxb_p200_v1#version U-Boot 2015.01-ge90bf25-dirty (Nov 27 2015 - 11:21:11) aarch64-none-elf-gcc (crosstool-NG linaro-1.13.1-4.8-2013.11 - Linaro GCC 2013.10) 4.8.3 20131111 (prerelease) GNU ld (crosstool-N

Thanks, after adding the correct resolution with xrandr I was able to change it via the settings menu.

Hi, I downloaded this image here: https://yadi.sk/d/srrtn6kpnsKz2/Linux/ARMBIAN/5.76/S905/4.20/Armbian_5.76_Aml-s905_Ubuntu_bionic_default_4.20.5_desktop_20190224.img.xz However the screen resolution is only 720p. How do I change it? The previous information about a hdmi.sh file is no longer valid (the file does not exist).