KennyM64

Validating
  • Content Count

    3
  • Joined

  • Last visited

Everything posted by KennyM64

  1. Hi Dalekun I have been bashing my head against this problem for a while now and while i've made some progress I have hit a brick wall. For some reason my keyboard input isn't going to the board. I'm using putty (and have tried others) with 115200,8,1,N,N. I've followed this example here and have run ‘./runme.sh’ which then populates putty with U-Boot 2013.10-rc4-g4c7d180-dirty (Mar 23 2017 - 15:50:02) CPU: Freescale i.MX6Q rev1.5 at 792 MHz Reset cause: POR Board: MX6-HummingBoard2 DRAM: 2 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 Card did not r
  2. Hi Russian NeuroMancer. Thanks for the suggestion. I gave this a try but it looks like U-Boot hasn't been built with the ums command, so unfortunately it's a no go. The page you referenced has a lot of interesting stuff on it though. I'll do some more reading and experimenting and see if I can get something working. It looks like the manufacturing cycle blew the fuses so it only boots from eMMC and doesn't fall back to USB. There is little information as to how to jumper these fuses back but I'll keep looking. :-( Cheers Ken
  3. Hi. I have a bunch of HummingBoard2 boards that have been used by a company called Vivo. Basically they allow schools to transfer video through Ethernet to monitors and projectors. I also want to do this but Vivi is a subscription based system so that SUX! I therefore want to blow Vivi away and load a clean Armbian. My issue is that the boards have no SD cards soldered to the board. They have power, 2xUSB, RJ45, HDMI connectors. They must therefore boot from eMMC. I found info on the board manufactures website., SolidRun, on how to use jumpers to select boot type. It was set