msev

So sorry for the noob question, but I don't want to create topics for just one question so asking it here....What would be the best way to connect two disks (either hdd or ssd) to the HC1? And could I use the gui in the "Armbian based OMV image" to setup both disks in either a RAID array or some rsync or some other solution for backuping data? Thanks and keep up the good work!

So how much hours of battery life do you guys get?

So should we anticipate full GPIO support in the future then?

But isn't the Pi Zero's wifi module even crappier because of the limited bandwidth, while these modules should have more bandwidth?

So you guys are anticipating good results out of this WIFI+BLE module? Better than OPI Lite?

So what is the problem with using Kodi on Armbian? Does everything work if I install it via ppa? Has anyone tried the 17 version? Why is jernej's old Openelec version preffered?

So would this bad wifi of the orange pi zero allow to serve a webpage that this firmware serves https://github.com/Dan-in-CA/SIP on my local network (+ some mqtt messages and polling a weather api), assuming the location of the opi0 is in some basement, but hopefully with not too bad wifi, since I have a wifi extender.

Thanks gailu very nice instructions!

Yeah pya20 seems way more straightforward, even I can see that, and it nice that someone has already done the pin-mapping for it. Still interested tho' in the "principle" of WiringOP, just in theory.

Gailu can you please describe the exact steps on which commands you need to type that you got this working? Do you use RC-522 in python?

So what is the principle of changing stuff? Can you give an example? I know that then I test it on the physical pin, but what do I need to change in the code?

Well I still don't have the hardware, so I can't help you with physical experiments, in addition I even can't find the pin mapping code , its probably in WiringPi.c but I dunno where i should look there.

So after you will have time, I'd appreciate it, since I can't even find in which file in WiringOP I need to change stuff, its not so evident like in py20a.

Can you share the new file please? Even if everything is not correct it would be a good start. Do you have it on github already?

But it is possible to correct them by hand? There is no "driver" limitation or something that would prevent from doing so?