Osoro

  • Content Count

    3
  • Joined

  • Last visited

About Osoro

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Arduino DHT11 Temperature-Humidity Sensor sensor version not supporting classical 1-wire protocol. Just bought raw DS18B20+ sensor, works fine.
  2. Hello. Im trying to configure w1-gpio bus on Armbian. There are default parametrs set: /sys/bus/w1/devices/w1_bus_master w1_master_timeout = 10 w1_master_timeout_us = 0 How to change them? Is this possible or require recompilation of w1-gpio module?
  3. Hello there. I have problems with connecting device with 1-wire protocol. Device: DHT11 Temperature-Humidity Sensor - It is Arduino version with pullup on the board. Board: Orange Pi Zero LTS (H2+) System: Linux orangepizero 5.10.21-sunxi #21.02.3 SMP Mon Mar 8 00:28:04 UTC 2021 armv7l armv7l armv7l GNU/Linux Based on instructions im preformed some steps: 1) Through armbian-config im enabled w1-gpio 2) Installed gpio app to get info about ports: +-----+-----+----------+------+--Orange Pi Zero--+------+----------+-----+-----+ | H2+ | wPi | Name