gTs2

or try putting blacklist sun4i_ss into /etc/modprobe.d/sun4i.conf

i don't know how to say this without sounding mean, but, read my last comment again

the only things left were either a wrong write or a wrong image dd img to sdcard under linux dd pipe to sha256sum, wrong dd img to sdcard under windows, dd pipe it to sha256sum, the same wrong value used win32diskimager, sha256 is correct, sdcard boots, i left it alone for for now to do its work either i don't know how to use dd maybe some of the weird options like notrunc or whatever, or dd is dumb now i'm going to play some obduction to calm down, i am angry at myself because i was almost certain your image was wrong... after all how could you develop for a board you don't even have? But I had more trust in you (because you are people) than i have in computers (because... computers...) and thankfully i insisted on checking as much as i could before i started pointing fingers thank you for your work and if you need anything tested on a cb2just ask, i'm handy with both hw/sw

cb2 2012-09-09, single SD card version power supply is a 3 A @5 V brick microsoft mouse and kb on usb, typical monitor on hdmi take sandisk ultra 16GB class10 card tests ok with h2testw tried fedora 22, dd .img to /dev/sdb, disconnect-reconnect sd card, mount sdb3, dd appropriate uboot, start cb2, system boots, lots of errors. reaches right before presenting login, stops there. blew compressed air into sd slot. tried different sd card (kingston 8GB class4) dd cb2 vanilla xenial armbian server .img to sandisk sdcard cb2 insists on booting from nand, trying to mount /dev/mmcblk0p1 says no valid partition whatsoever tried bs=1M, bs=10M. tried different sdcard. tried dd under windows 10 on desktop tried dd under lubuntu on laptop the linaro installation existing in nand boots fine. has about a page worth of errors in dmesg, but it boots, X and all. second card tests ok with h2testw wrote a script to check reading and writing to sd card, on the cb2, with dd and sha1, sha256 and md5 card works ok not sure what else to try does this work for you guys? I mean, you guys developing armbian, have you successfully booted this image on a cb2? Can you give it a try?