andrikll

I thought it was because I didn't find the right resistors... could you tell me where to read about it? .....read the message again, I understand you saw a diagram where not divorced this contact?

No questions. Maybe I'll try to still connect there led desolder resistor and adding1Kom from led? Just blinking, suddenly working? A few hours later. In General, I guess what I do not so the house was measured or tester battery hooked. Soldered to contact USB (4-point-plus and 2 from GND) in my work. All true as on the picture leonidy-85. Then can I continue?

R40 point D. Between 3.3v and a point D 0Ohm. here that the not so...

a-3.3v 3.26kom b-3.3v 2.47kom c-3.3v 3.2 kom d-3.3v 0 om e-3.3v 1.3kom f-3.3v 12.2kom

Just the difficulty of understanding the translation. I'm not sure those are the resistance. I am attaching the measurements, as well isvery top point r65 r68 Inn on the diagram are not soldered） here there is 12.2 K and 1.3 K to 3.3v point. May indicate the source of the schemes and there are different generations at version1.4 Board?

Got it, I'll call and take a picture of macro. Do I understand correctly that i need to the right (under the scheme) point R157 connect and desolder the resistor? R40 desoldering it is desirable to not have voltage on contact from?

Hello, It can is possible to call this contact? I have too v1.4