Sylva1n Posted September 16, 2022 Posted September 16, 2022 Hello, on a fresh install (Armbian_22.08.1_Orangepi3_jammy_current_5.15.63), the ethernet eth0 interface doesn't retrieve any IP. Quote root@orangepi3:~# ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff inet6 fe80::7bd3:dc4e:7cef:fb02/64 scope link noprefixroute valid_lft forever preferred_lft forever 3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000 link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff Here comes the kernel ethernet related messages: Quote dmesg -c [ 28.317964] phy_rtl8211e_led_fixup in [ 28.319733] dwmac-sun8i 5020000.ethernet eth0: PHY [stmmac-0:01] driver [RTL8211E Gigabit Ethernet] (irq=POLL) [ 28.320275] dwmac-sun8i 5020000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0 [ 28.320770] dwmac-sun8i 5020000.ethernet eth0: No Safety Features support found [ 28.320779] dwmac-sun8i 5020000.ethernet eth0: No MAC Management Counters available [ 28.320786] dwmac-sun8i 5020000.ethernet eth0: PTP not supported by HW [ 28.321144] dwmac-sun8i 5020000.ethernet eth0: configuring for phy/rgmii-id link mode [ 31.394770] dwmac-sun8i 5020000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx [ 31.394820] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready After that, I have launched a dhclient command that took several minutes to stop. Then, an APIPA address is attributed to eth0 nterface. Quote root@orangepi3:~# ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff inet 169.254.9.46/16 brd 169.254.255.255 scope link eth0:avahi valid_lft forever preferred_lft forever 3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000 link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff inet 169.254.12.106/16 brd 169.254.255.255 scope link wlan0:avahi valid_lft forever preferred_lft forever So I have launched armbian-config to set the eth0 to static. And it worked. Quote root@orangepi3:~# ip a 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 link/ether 02:07:45:83:22:c4 brd ff:ff:ff:ff:ff:ff inet 192.168.123.111/24 brd 192.168.123.255 scope global noprefixroute eth0 valid_lft forever preferred_lft forever 3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN group default qlen 1000 link/ether 08:e9:f6:93:61:6a brd ff:ff:ff:ff:ff:ff inet 169.254.12.106/16 brd 169.254.255.255 scope link wlan0:avahi valid_lft forever preferred_lft forever But how to make DHCP works? Thank you PS all others devices on my network can retrieve an IP by DHCP. I also tried others OS on my Orange Pi 3 boards and they grab an IP. The issue comes from Armbian. 0 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.