Jump to content

USB serial not working with Bullseye Minimal/Regular CLI version (stops working after initial setup)


Recommended Posts

Posted (edited)

Hi,


I've installed minimal cli version and it restarts when connected to PC via on-board USB-C connector. Board hangs after:

[  OK  ] Reached target Hardware activated USB gadget.

Host computer does:

[ 4881.959467] usb 1-5: new high-speed USB device number 47 using xhci_hcd
[ 4882.140301] usb 1-5: New USB device found, idVendor=0525, idProduct=a4a6, bcdDevice= 5.15
[ 4882.140315] usb 1-5: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 4882.140322] usb 1-5: Product: Gadget Serial v2.4
[ 4882.140327] usb 1-5: Manufacturer: Linux 5.15.80-rockchip64 with ff580000.usb
[ 4883.572730] usb 1-5: USB disconnect, device number 47
[ 4884.079492] usb 1-5: new high-speed USB device number 48 using xhci_hcd
[ 4884.229424] usb 1-5: device descriptor read/64, error -71
[ 4884.499520] usb 1-5: device descriptor read/64, error -71
[ 4884.769501] usb 1-5: new high-speed USB device number 49 using xhci_hcd
[ 4884.919510] usb 1-5: device descriptor read/64, error -71
[ 4885.189426] usb 1-5: device descriptor read/64, error -71
[ 4885.309571] usb usb1-port5: attempt power cycle
[ 4885.779457] usb 1-5: new high-speed USB device number 50 using xhci_hcd
[ 4885.779556] usb 1-5: Device not responding to setup address.
[ 4885.999459] usb 1-5: Device not responding to setup address.
[ 4886.219537] usb 1-5: device not accepting address 50, error -71
[ 4886.369509] usb 1-5: new high-speed USB device number 51 using xhci_hcd
[ 4886.369639] usb 1-5: Device not responding to setup address.
[ 4886.589578] usb 1-5: Device not responding to setup address.
[ 4886.809467] usb 1-5: device not accepting address 51, error -71
[ 4886.809571] usb usb1-port5: unable to enumerate USB device

 

On regular CLI version it seems to work for now. Or in fact it stops working after initial setup!

Edited by MrJake222
new info
  • MrJake222 changed the title to USB serial not working with Bullseye Minimal/Regular CLI version (stops working after initial setup)

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines