L.A. Posted May 13, 2023 Posted May 13, 2023 Recently acquired an Espressobin Ultra. When I attach an ssd (a Kingston 500GB NVMe 2280 M.2) to it the device won't start. It displays no sign of powering on. I have tried two different SSDs. no difference. Without one attached as soon as power sis applied all the ethernet interface LEDs flash briefly. With the SSD card that doesn't happen. There is no activity at the console. Do I need to change jumpers or do some other setting at the Marvell prompt before attaching it? Help would be much appreciated. Many thanks LA. 0 Quote
KV1 Posted March 5 Posted March 5 Did anyone ever figure this out? looks like i have the same problem. GS clarified that NVMe isn't actually supported. I didn't understand but it turns out the formfactor supports many different types of drives. Also the M-Key vs B-Key are so close you can inadvertently install the drive upside down, and it sorta fits. I ended up getting a B+M Key 2280 SATA only drive, and the device worked fine (be sure to install it the correct way!). 0 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.