Installation Instructions for TV Boxes with Amlogic CPUs

[Maurizio Finesso]

Hi @John Taylor, @SteeMan,

unfortunatly it takes me time because I was not at home. I found that I can use the minimal or server version and only using Rufus. If I use Balena Etcher it doesn't create the fat32 partition named Boot. now I'm struggling because I would like to use the system on SD card but after that I do any changing for example IP from dynamic to static using armbian-config a lot of messages comes saying that EXT4FS is in read-only mode and I can use the system but not to install programs. I'm a little afraid to install on eemc because I have no android image. It is an old MXQ pro mini from leelbox.

[2mg]

@Maurizio Finesso@John Taylor@SteeMan

 

I've had success using USB stick instead of SD Card (see my post on 1st page), however now the BOOT Fat32 partition was hidden for some reason, I used DiskGenius to unhide it.

I didn't test this on the tv box yet.

 

 

This also goes against what is being said in this thread (that there are no more Fat32 paritions visible in Windows) from this thread:

 

Edited 28 minutes ago by 2mg