Jump to content

Recommended Posts

Posted

Hi,
I have orange pi 5. I searched all over internet for information how to set on startup/power on GPIO pins behavior, but i cannot find anything.
Most of GPIO pins are set to IN mode 1. Sadly I need them to output mode 1.
I am scared something could burn this way since i set them to though wiringPI after kernel boot sequence is complete.
Can some one give information how I can set them up at earlier point when I power on the board?
I found that DTB/DTS file could do it. But there is no clear information / pin addresses I should set.
Thanks in advance!
Regards!
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines