maximilian fletkar Posted Thursday at 09:32 AM Posted Thursday at 09:32 AM hello! Can help me about orange 3b, I want to adapt one dts file to my board, how to correctly indicate the names of the pins, the example gives the following sample entry: https://mjmwired.net/kernel/Documentation/devicetree/bindings/display/panel/sitronix,st7701.txt reset-gpios = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* LCD-RST: PD24 */ how to correctly fix this for my board? 0 Quote
ning Posted Thursday at 01:34 PM Posted Thursday at 01:34 PM I think OPI 3B supports eDP panel, but sitronix is MIPI panel, right? 0 Quote
ning Posted Thursday at 01:49 PM Posted Thursday at 01:49 PM there is not reset pin on this connecter? unless you change I2C1_SCL_M0/I2C1_SDA_M0 to reset pin, according to your panel's interface define. 0 Quote
maximilian fletkar Posted Thursday at 02:09 PM Author Posted Thursday at 02:09 PM This board has support for mpi dsi 2 lines. There are no reset pins on this connector. I thought that I would add a reset and power supply via gpio There in the driver settings you also need VCC-supply and IOVCC-supply 0 Quote
ning Posted Thursday at 02:35 PM Posted Thursday at 02:35 PM yuo can't use GPIO as power supply, will break soc. 0 Quote
maximilian fletkar Posted Thursday at 02:52 PM Author Posted Thursday at 02:52 PM I understand, thank you. But how can I then correctly specify I2C1_SCL_M0 as a reset line? 0 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.