MarekBelisko Posted November 18, 2019 Posted November 18, 2019 Hi, I bought x96mini with 2G RAM and 16G emmc and booting to android works fine. I want to run armbian on it so I followed this post: https://blog.danman.eu/bricking-and-unbricking-vontar-x96-mini/ to solder serial console. Aftre plugging to pc and starting minicom I cannot see any info out of serial console. Does anybody experience similar or something else must be done to have output on serial console? Thanks a lot. Marek
MarekBelisko Posted November 28, 2019 Author Posted November 28, 2019 Resolved, I need to solder 0ohm resistors on pad to have UART working -> maybe it will help someone in future also
hexdump Posted November 28, 2019 Posted November 28, 2019 @MarekBelisko: can you please be a bit more specific what kind of resistor you had to solder where? a lot of thanks in advance - hexdump
MarekBelisko Posted November 28, 2019 Author Posted November 28, 2019 If you see test points close to RX, TX there are 2 pads which needs to be shortcut (with 0ohm resistor) to have RX, TX signals on test points.
Recommended Posts