MarekBelisko Posted November 18, 2019 Share Posted November 18, 2019 Hi, I bought x96mini with 2G RAM and 16G emmc and booting to android works fine. I want to run armbian on it so I followed this post: https://blog.danman.eu/bricking-and-unbricking-vontar-x96-mini/ to solder serial console. Aftre plugging to pc and starting minicom I cannot see any info out of serial console. Does anybody experience similar or something else must be done to have output on serial console? Thanks a lot. Marek Link to comment Share on other sites More sharing options...
MarekBelisko Posted November 28, 2019 Author Share Posted November 28, 2019 Resolved, I need to solder 0ohm resistors on pad to have UART working -> maybe it will help someone in future also Link to comment Share on other sites More sharing options...
hexdump Posted November 28, 2019 Share Posted November 28, 2019 @MarekBelisko: can you please be a bit more specific what kind of resistor you had to solder where? a lot of thanks in advance - hexdump Link to comment Share on other sites More sharing options...
MarekBelisko Posted November 28, 2019 Author Share Posted November 28, 2019 If you see test points close to RX, TX there are 2 pads which needs to be shortcut (with 0ohm resistor) to have RX, TX signals on test points. Link to comment Share on other sites More sharing options...
Recommended Posts