Jump to content

PSU voltage pinouts for Helios4


youe

Recommended Posts

I've been using a Helios4 for nearly 2 years now and it's been fantastic.  A couple days ago, it stopped working though.  The serial console revealed a boot loop at "U-Boot SPL" and only showing the disks, but never attempting to boot the OS.  I did some forum searching and discovered the PSU could be the issue.  Using a multimeter, I tested the PSU pins and I get the following (see diagram):


PIN 1: +2.66V (fluctuates between 2.64-2.66)
PIN 2: +2.66V (fluctuates between 2.64-2.66)
PIN 3: GND
PIN 4: GND

 

What are the voltages that Helios4 expects for these pins?  Should both 1 & 2 be 12V or should one be 12V and the other 5V?


I already ordered the following PSU as per another thread (however, this won't arrive for another week)
https://www.amazon.com/gp/product/B07NCG1P8X/

 

 

710eaim2N3L._AC_SL1500_.jpg

Edited by youe
Link to comment
Share on other sites

Since I had collected as much information from the broken AC adapter brick as possible, I decided to cut off the connector.  This revealed only 2 wires which meant there is only one possible configuration.  Both pins 1 and 2 must be 12V.

 

I grabbed one of my old computer power supplies, and fashioned a terminal connector to tie the 2 wires to the 12V rail and ground.  I verified the 4 pins on the connector, plugged it in and my Helios4 booted up without any issues.  I'm still waiting about a week and I'll swap out my 500W temporary PSU when it arrives.

 

For anyone with similar power issues, hopefully this thread may be helpful to them.

 

 

Here's the appropriate pinouts of the 4-pin AC adapter required for Helios 4 (see previous diagram for pin locations):
PIN 1: +12
PIN 2: +12
PIN 3: GND
PIN 4: GND

Link to comment
Share on other sites

You are correct, the Helios4 PSU is outputting DC 12V / 8A.

PIN 1: 12 VDC
PIN 2: 12 VDC
PIN 3: GND
PIN 4: GND

 

And yes between the 4-pin connector and the AC/DC power adapter it's just 2 wire ( +12VDC (red) and GND (black) ). So it should be easy to replace the power block with another while keeping the 4-pin connector as you did ;-)

 

image.png.55eeed5a6f30a497635ac5b85ed0ace0.png

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines