jgauthier Posted January 18, 2023 Share Posted January 18, 2023 Hello, I am using a NanoPi Duo2 with Armbian 22.11 and Kernel 5,15,80. This device uses an AP6216 wireless interface, which I have noticed are pretty common on sunxi based boards. I ran some bandwidth tests and had pretty poor results: [ ID] Interval Transfer Bandwidth [ 3] 0.0000-1.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 1.0000-2.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 2.0000-3.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 3.0000-4.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 4.0000-5.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 5.0000-6.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 6.0000-7.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 7.0000-8.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 8.0000-9.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 9.0000-10.0000 sec 129 KBytes 1.05 Mbits/sec Not sure if the issue was the driver, hardware, or otherwise I connected a USB wifi dongle and disabled the AP6216. I've tested with the same results again: [ ID] Interval Transfer Bandwidth [ 3] 0.0000-1.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 1.0000-2.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 2.0000-3.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 3.0000-4.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 4.0000-5.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 5.0000-6.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 6.0000-7.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 7.0000-8.0000 sec 127 KBytes 1.04 Mbits/sec [ 3] 8.0000-9.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 9.0000-10.0000 sec 129 KBytes 1.05 Mbits/sec [ 3] 0.0000-10.0191 sec 1.25 MBytes 1.05 Mbits/sec It's my suspicion that the issue is now elsewhere - but where? I have no idea. Thanks for any ideas. 0 Quote Link to comment Share on other sites More sharing options...
jgauthier Posted January 18, 2023 Author Share Posted January 18, 2023 Good news! I'm dumb! iperf defaults to a 1M transfer rate over UDP. Easily changed with -b option. 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.