Need help for GPIO with BananaPro Armbian Mainline

[Marcelm2000]

Hello,

actually i have "Bananian" with the kernel "3.4.113-bananian", and I would like to switch to the Armbian mainline kernel!

 

My problem / question is how does it work with the GPIO in the mainline kernel?

 

I use these commands under the legacy kernel... (I use the modified WiringPI from LeMaker)

echo "17" > /sys/class/gpio/export
echo "out" > /sys/class/gpio/gpio17/direction
echo "1" > /sys/class/gpio17/value

But these unfortunately no longer work under the mainline kernel!

 

I don't understand how i calculate now the right GPIO Pin. (http://linux-sunxi.org/GPIO#Accessing_the_GPIO_pins_through_sysfs_with_mainline_kernel)

 

I look forward to your help!

 

Greeting,

Marcel

[martinayotte]

As the Linux-sunxi page you've mentioned :

Quote

(position of letter in alphabet - 1) * 32 + pin number

 

So, in your example, the pin is PA17.

If we take another pin, lets say PC12 : it would be 76.

If we take another pin, lets say PD5 : it would be 101.

[Marcelm2000]

Hello,

thank you for your reply!

 

I think it is not PA17, because i'm connected physically to Pin 11 and in the Schematic

(http://forum.lemaker.org/thread-10852-1-1.html) is CON6-P11 = PI19 and that is 257, right?

 

I will test both afterwards!

[squid4t2]

Hi Marcelm,  try your calculation again ..  I think you may find it works out to 275.

 

I hope this sorts the problem for you.

 

8 x 32 plus 19

[Marcelm2000]

Thank you squid4t2!

It works great.

 

Greeting,

Marcel

[squid4t2]

Hi Marcelm, glad to be of help.

 

I found sorting GPIO pins / inputs / outputs quite a challenge to start with as Odroid, Pine and Raspi etc all had / have different values.

 

All very confusing ....