Orange pi zero 3 SPI cs pin

[adif]

I'm trying to configure the CS (Chip Select) pin on my Orange Pi Zero 3. I added overlays=spi-spidev to the /boot/armbianEnv.txt file, created my own dtbo file, and tried all possible methods suggested by ChatGPT. I've been struggling for two weeks with no success. I haven't been able to switch the CE1 pin to alt4 state; it only stays off, nothing else. Is it even possible to work with SPI on this board?

[SteeMan]

Moved to the correct forum (community support).  This is not a supported board.  Adjusted the tag to reflect the correct board.

[WDR_s]

Did you get it to work?

Edited 10 hours ago by WDR_s

[adif]

CLK, MOSI, MISO is work, but CS not work.  In gpio readall : CLK1 - ALT4, MOSI1 - ALT4, MISO1-ALT4, but CE1 - OFF. How change mode CE1 to ALT4?