I was wondering if anyone had been able to get this working ? And, yes i know that OPI-Win is WIP/testing.
I read some stuff here & on the linux-sunxi irc log that seemed to say that it should work & I've tried the following without luck. I was wondering if someone with alittle more knowledge about this may be able to help or point me in the right direction.
I also tried to compile u-boot v2017-09 but it fails with a sdram too big error I tried to backport some of the config to 2017-07 but that'll take time i expect ...
/boot/armbianEnv.txt (many combinations of this)
disp_mode=720p60
disp_dvi_compat=1
verbosity=7
/boot/boot.cmd (many combinations of this)
setenv stdout=serial,vga
setenv stderr=serial,vga
setenv console=tty1 (i've also tried tty0, tty2 etc)
Question
t-bob
Hi,
I was wondering if anyone had been able to get this working ? And, yes i know that OPI-Win is WIP/testing.
I read some stuff here & on the linux-sunxi irc log that seemed to say that it should work & I've tried the following without luck. I was wondering if someone with alittle more knowledge about this may be able to help or point me in the right direction.
I also tried to compile u-boot v2017-09 but it fails with a sdram too big error
I tried to backport some of the config to 2017-07 but that'll take time i expect ...
/boot/armbianEnv.txt (many combinations of this)
disp_mode=720p60
disp_dvi_compat=1
verbosity=7
/boot/boot.cmd (many combinations of this)
setenv stdout=serial,vga
setenv stderr=serial,vga
setenv console=tty1 (i've also tried tty0, tty2 etc)
setenv bootargs console=tty0 hdmi.audio=EDID:0 disp.screen0_output_mode=720p60 root=/dev/mmcblk0p1 rootwait panic=10
setenv video-mode sunxi:1024x768-24@60,monitor=dvi,hpd=0,edid=0
Many thanks in advance
TB
Link to comment
Share on other sites
0 answers to this question
Recommended Posts