MarkRMonaco Posted September 7, 2017 Posted September 7, 2017 Hello, I recently purchased a Banana Pi M2, and downloaded the latest desktop image to my SanDisk 32gb MicroSD card. Everything boots-up. However, the only interface that seems to be able to get onto the internet properly is wlan0 (Wireless). Ethernet, regardless of DHCP (registers properly) or Static does not seem to route properly. For example, I am not able to ping or SSH the device from another PC, and the Pi (itself) cannot ping/access any local IPv4 address as well. Internet access fails, and points to DNS not working properly (even though servers are specified). Tried many different methods, including taking management/control away from "NetworkManager", but have not helped at all. Network switch is good, and other devices can access the internet with no problems. I ultimately need to get the eth0 interface to work as my primary so i can completely disable wlan0. Was purchased because it supports gigabit.
Igor Posted September 7, 2017 Posted September 7, 2017 4 hours ago, Mark R. Monaco said: the latest desktop image Exactly which image did you download? Do you have Banana M2 or M2+ ?
MarkRMonaco Posted September 7, 2017 Author Posted September 7, 2017 I only have the standard M2, and not the plus model. As far as the image is concerned, I downloaded the "Ubuntu Desktop - Mainline Kernel" image that is available on the Banana Pi M2 page.
Igor Posted September 7, 2017 Posted September 7, 2017 That should work. Hmm. Try v5.25, https://dl.armbian.com/bananapim2/archive ... what about stock images from board maker? Tried any?
MarkRMonaco Posted September 8, 2017 Author Posted September 8, 2017 The board maker apparently doesn't support it anymore. I'll give v5.25 a try tomorrow.
Recommended Posts