How to control an infrared YS-IRTM module send/receive

[jscax]

Hi all,

I'm trying to understand how to make an infrared tx/rx module working.

 

This is the module: https://www.aliexpress.com/item/5V-IR-Infrared-Remote-Decoder-Encoding-Transmitter-Receiver-Wireless-Module/32528109291.html

Is there a way to make this works in userspace?

Overlays? From the docs I was only able to understand how to enable existing overlays.

I enabled cir, this is from my armbianEnv.txt:

overlays=cir i2c0

but I don't know how to configure pins: which is rx which tx.

Do I need to write down a new/custom overlay?

 

I think that configuring pins is crucial to enable IR communication at some level but I don't know how and where.

 

In the OPi0 world seems like all IR is about the expansion board which I don't have and I don't need because what's important to me is to send IR signal, more than receiving.

 

Last but not least I found this: https://github.com/Aschhoff/Orange-Pi-Infrared which is pyA20 powered and so root dependent and I would like to find a rootless solution, if possible.

 

Please, can someone point me in some direction?

 

thank you very much and pardon me for being such a newbie asshole 

[chrisf]

Looks like that module has a UART (serial) interface, not I2C

 

The aliexpress page doesn't say anything about how it communicates over the serial connection.

 

There's a forum thread here about it: https://forum.arduino.cc/index.php?topic=359707.0

[jscax]

ok, the uart layeroverlay should be a good point to start with

 

thank you

[jscax]

it's a super easy/normal uart communication  and it just works following the datasheet protocol specification