Jump to content

cpufrequtils/armbian-config does not load all availiable modes


Recommended Posts

Posted

I'm on a Rockpro64 rev2.1 and wanted to use the maximum of the availiable Power of this SoC, so i tried using cpufrequtils and the amrbian config for doing so and noticed two things:

I can only set one of my CPU's frequencies and the maximum is 1800 MHz, so i searched this forum for a while  and found out how to show the device tree table which is currently loaded(dtc -I fs /sys/firmware/devicetree/base/)

and there is one unused mode for both of my CPUs, a 1992 MHz mode for the big chip and a 1512 MHz mode for the small chip, and at this point im stuck.

What could i do to load this modes in the cpufrequtils or the armbian config?

  Reveal hidden contents
Posted

RK3399 board support is WIP, "for testing only" and problems are expected! If you want to use those boards for some real cases, don't. You need minimum of 5 approved posts to collaborate in this forum!

https://forum.armbian.com/forum/33-rockchip-3399/


With another words. There are many more critical issues that needs attention.

Guest
This topic is now closed to further replies.
×
×
  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines