1 1
martini1992

Helios4 requires USB serial console cable connected to function

Recommended Posts

Armbianmonitor:

Board ran fine when I did initial setup outside the case with no disks or fans connected, was able to SSH in fine.

 

After assembling the case and plugging in all the disks and OLED display the board will only boot whilst the serial console is connected. Without it dumps to the initramfs prompt.

 

Once booted the board runs fine, until I disconnect the serial console cable then anything running from memory is fine, but any access to the linux system on the SD card throws IO errors.

 

On replugging the serial console cable I see more SD read/write errors.

 

Regards,

Martin

Share this post


Link to post
Share on other sites
On 9/20/2019 at 3:09 PM, martini1992 said:

SD read/write errors

 

Bad or fake SD card is one of the most frequent (generic) issues in this SD card powered world. Did you try different SD card?

Share this post


Link to post
Share on other sites

Yeah, I've used it quite a lot in other systems before, unless the die has cracked over time I'm inclined to think it's ok.

 

Though since I made this post it seems to be working as normal. Strange. So maybe this can be marked as fixed for now. Don't really know what fixed it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
1 1