OpenglMan 1 November 18 Hello, For a custom board using the H5 or H3 SoC, i would like to make the Calibration of the DDR3 chip. I think that the available information is very little. I will report here the steps I am taking. Anyway, I would greatly appreciate any information that could be provided to me. Thanks in advance 0 Share this post Link to post Share on other sites
jernej 169 November 18 I don't think any AW board has custom DDR settings. H3 & H5 DDR3 driver currently supports only 1333MHz timings. It would be great to enable per-board settings, but you will have to come up with that yourself. Remember, there is no documentation for DRAM controller, so all that was reverse engineered. 0 Share this post Link to post Share on other sites