aprayoga Posted November 12, 2020 Posted November 12, 2020 (edited) CURRENT branch (Linux Kernel 5.10) Feature Support Status Remarks Shutdown OK Reboot OK Suspend to RAM Not Supported USB host controller refuses to enter suspend mode 2.5G Ethernet (2.5G speed) OK TX offload disabled by default, can be enabled for better performance 2.5G Ethernet (1G speed) Performance issue Requires hardware fix. Main Power/UPS status OK Status can be read from sysfs Battery Charging OK Status can be read from sysfs UPS configuration OK Auto shutdown after 10 min of power loss. USB Type C - Host OK use dwc3-0-host overlay. Enable P13 jumper to be able to use USB 2.0 device. USB Type C - Gadget OK use overlay to enable USB device mode. refer to this link USB Type C - DisplayPort OK eMMC Boot OK SPI Boot Not Supported Recovery Button OK To use maskrom, jumper P13 must be enabled. USB LED Not Supported usbport led trigger does not support activity and only works with USB 2.0 device LAN LED OK default to eth0 activity Wake On LAN Not Supported Suspend still have issue Armbian 21.02 Edited February 8, 2021 by aprayoga Update to Armbian 21.02
aprayoga Posted November 13, 2020 Author Posted November 13, 2020 (edited) LEGACY branch (Linux Kernel 4.4) Feature Support Status Remarks Shutdown Partial Fails to shutdown PMIC and triggers crash, HDD already parked Reboot Partial Similar like shutdown but Watchdog triggers the reboot so it appears successful Suspend to RAM Not Supported Fails to resume operation after wake up 2.5G Ethernet (2.5G speed) OK 2.5G Ethernet (1G speed) Performance issue Requires hardware fix. Main Power/UPS Status OK Status can be read from sysfs Battery Charging Status Not Supported UPS configuration OK Auto shutdown after 10 min of power loss. USB Type C - Host OK USB Type C - Gadget OK Use g_mass_storage kernel module USB Type C - DisplayPort OK eMMC Boot OK SPI Boot Not Supported Recovery Button OK To use maskrom, jumper P13 must be enabled. USB LED Not Supported LAN LED Not Supported Wake On LAN Not Supported Suspend still have issue Armbian 21.02 Edited February 9, 2021 by aprayoga Update to Armbian 21.02
aprayoga Posted February 8, 2021 Author Posted February 8, 2021 CURRENT branch (Linux Kernel 5.10) Feature Support Status Remarks Shutdown OK Reboot OK Suspend to RAM Not Supported USB host controller refuses to enter suspend mode 2.5G Ethernet (2.5G speed) OK TX offload disabled by default, can be enabled for better performance 2.5G Ethernet (1G speed) Performance issue Requires hardware fix. Main Power/UPS status OK Status can be read from sysfs Battery Charging OK Status can be read from sysfs UPS configuration OK Auto shutdown after 10 min of power loss. USB Type C - Host OK use dwc3-0-host overlay. Enable P13 jumper to be able to use USB 2.0 device. USB Type C - Gadget OK use overlay to enable USB device mode. refer to this link USB Type C - DisplayPort OK eMMC Boot OK SPI Boot Not Supported Recovery Button OK To use maskrom, jumper P13 must be enabled. USB LED Not Supported usbport led trigger does not support activity and only works with USB 2.0 device LAN LED Supported default to eth0 activity Wake On LAN Not Supported Suspend still have issue Armbian 21.02 Note: - UPS action will be changed into based on battery voltage threshold rather than countdown timer. (PR 2259) - To change LAN LED network device, change eth0 on /etc/systemd/system/helios64-heartbeat-led.service at line 9 into eth1
Recommended Posts