Get ssh connection reset by peer on Armbian bullseye, TX3 mini

[kendoodoo]

Today I was installing bullseye on it, then when me try to ssh with wifi, it just shows me :

 

kex_exchange_identification: read: Connection reset by peer
Connection reset by 192.168.1.X port 22

 

I installed the 20.10 version of Armbian, so if someone knows how to fix this, please reply. Thanks.

[Werner]

Moved to tvboxes

[SteeMan]

Please provide more information on what you have done.  What build have you installed (exact file name), where did you download if from, what instructions have you followed to install. 

[CryBaby]

It might help to use 

HostkeyAlgorithms +ssh-rsa

in your .ssh/config stanza.

Run ssh with -v for some debug output.

 

I also have key exchange problems connecting to bullseye from newer Debian (and Windows) for which the only solution has been to use something else.

[kendoodoo]

Wifi chip is a rtl8723bs, with the Armbian of balbes150 from https://users.armbian.com/balbes150/arm-64/. So here's the log from the chip:

 

[74759.888047] RTL8723BS: rtw_set_802_11_connect(wlan0)  fw_state = 0x00000008
[74759.934607] RTL8723BS: start auth
[74759.954602] RTL8723BS: auth success, start assoc
[74759.966775] RTL8723BS: rtw_cfg80211_indicate_connect(wlan0) BSS not found !!
[74759.966801] RTL8723BS: assoc success
[74760.063469] RTL8723BS: send eapol packet
[74760.071278] RTL8723BS: send eapol packet

 

When got no activity going around, it just goes back to normal and I can ssh. Nmap scan shows ssh still active:

 

Nmap scan report for 192.168.1.X
Host is up (0.012s latency).
Not shown: 99 closed tcp ports (conn-refused)
PORT   STATE SERVICE
22/tcp open  ssh

Nmap done: 1 IP address (1 host up) scanned in 5.93 seconds

 

I try upgrade system, different distros, place close to router, open the case. Still helpless. 

[SteeMan]

Does wired ethernet connection work?

Please read the following TV Box FAQ post: https://forum.armbian.com/topic/16976-status-of-armbian-on-tv-boxes-please-read-first

Note: I have about 10 amlogic based tv boxes, including 4 tx3 minis and I don't have wifi working on any of those boxes.  You should not expect wifi to be working.  If you get it working you are lucky.