UART won't connect no matter what I do

[devmichelcastilho]

Armbianmonitor:

https://paste.armbian.com/xuzeyolapi

So I'm trying to connect with a UART cable from my PC to the board (OPI3LTS). Here's what I did so far:
 

In desperation, I double checked every connection, to no avail. My devices are powered separately, so only the RX and TX cable are connected, and they are crossed as they should.

 

Set up permissions:

sudo chmod 666 /dev/ttyUSB0

 

Add user to dialout:

sudo adduser <user> dialout

 

Install minicom:

Set up minicom with the correct address: /dev/ttyUSB0
Set up the correct baud rate (115200 in this case)
Turn off flow control

 

Tried connecting via "screen", minicom and putty, all of them just show me a black CLI I can't write in.

 

Help? 🥲

Edited March 16 by devmichelcastilho

[devmichelcastilho]

Still no clue what's happening...

[IBV]

Hi,

 

are you using a usb to serial converter or the real serial com port?

I did not see any ttyUSB0 listed in your boot log.

In case of the real serial com port you should not be using /dev/ttyUSB0, but /dev/ttyS0.

 

[Werner]

Using screen is sufficient. No settings besides baud rate (115200 for any Allwinner) need adjustments.

As mentioned above make sure your serial device is correct. If you are unsure, simply

- unplug

- run sudo dmesg -ew

- plug in and check output in the terminal with the command above.

 

Also make sure wiring is correct. Ground to ground and rx/tx crossed.

[devmichelcastilho]

Thank you so much for the responses, IBV and Werner!

I'm connecting from the PC USB to the SBC serial com port, then attempting to run Screen from the PC.

[IBV]

Did you also start screen or minicom on the SBC ?

For example:
 

screen /dev/ttyS0 115200

 

And on PC:

screen /dev/ttyUSB0 115200

Make sure you use the same speed on both sides.