I want to boot Hummingboard Edge with Armbian (Jessie - kernel 3.14.54) , but I'm experiencing problems during the booting procedure.
Bootloader is searching for some files then it gives up. I have copied two files (imx6q-hummingboard2.dtb to imx6q-hummingboard.dtb) to /boot/dtb/ folder. It looks like it starts with the kernel, but it never loads completely. Below are the steps:
U-Boot SPL 2013.10-rc4-sun7i (Oct 11 2015 - 20:45:45)
Boot Device: SD1
spl: error reading image u-boot.img, err - -1
Load image from RAW...
U-Boot 2013.10-rc4-sun7i (Oct 11 2015 - 20:45:45)
CPU: Freescale i.MX6Q rev1.5 at 792 MHz
Reset cause: POR
Board: MX6-HummingBoard2
DRAM: 2 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Hit any key to stop autoboot: 0
mmc0 is current device
** File not found /boot.scr **
** File not found /uEnv.txt **
** File not found /zImage **
** File not found /uImage **
437 bytes read in 130 ms (2.9 KiB/s)
Running bootscript from mmc ...
## Executing script at 10800000
40257 bytes read in 421 ms (92.8 KiB/s)
6015384 bytes read in 584 ms (9.8 MiB/s)
Kernel image @ 0x12000000 [ 0x000000 - 0x5bc998 ]
## Flattened Device Tree blob at 18000000
Booting using the fdt blob at 0x18000000
Using Device Tree in place at 18000000, end 1800cd40
Starting kernel ...
I would be happy, if you can give me some pointers on how to solve this problem.
Question
ingeniero
Hello,
I want to boot Hummingboard Edge with Armbian (Jessie - kernel 3.14.54) , but I'm experiencing problems during the booting procedure.
Bootloader is searching for some files then it gives up. I have copied two files (imx6q-hummingboard2.dtb to imx6q-hummingboard.dtb) to /boot/dtb/ folder. It looks like it starts with the kernel, but it never loads completely. Below are the steps:
I would be happy, if you can give me some pointers on how to solve this problem.
With Solidrun linux port it works normally.
Thank you.
Link to comment
Share on other sites
6 answers to this question
Recommended Posts