blub4747 Posted December 28, 2018 Posted December 28, 2018 Hi forum, I want use my R1 board as a switch and if possible to run some services as the same if possible. Now when I look in /etc/network I do see a lot of different .conf files in that folder, but I do not really know how to use or them. Therefore my questions. 1. can I use my board as switch and can I run as the same services. 2. How do I use these config files and how do I interpret the results. Thx,blub4747
Tido Posted December 28, 2018 Posted December 28, 2018 Hi blub, Good choice to call yourself blub, you have to dive deep well, just 3 pages... https://forum.armbian.com/topic/3476-bpi-r1-with-new-b53-switch-driver-dsa/ and no, there is no short answer. Because if you ain't understand, you cannot fix it.
sfx2000 Posted December 29, 2018 Posted December 29, 2018 12 hours ago, blub4747 said: I want use my R1 board as a switch and if possible to run some services as the same if possible. Want or need? OpenWRT/LEDE has some good info on the mapping of the switch ports, so that might be helpful... https://openwrt.org/toh/lamobo/bananapi_r1 Anyways - even for a dev, roll up your sleeves - that board isn't for noobs...
blub4747 Posted January 10, 2019 Author Posted January 10, 2019 Hi just wanted to update this post and let you guys know that I did look at openwrt for for my board. And that I was aware that there was a version of openwrt years back and I that I thought that there would be further development for it. Turns out that the version of the openwrt I found seems to be top of the line. very nice!
Tido Posted January 10, 2019 Posted January 10, 2019 3 hours ago, blub4747 said: top of the line Link ?
sfx2000 Posted January 16, 2019 Posted January 16, 2019 On 1/10/2019 at 7:25 AM, Tido said: Link ? It's the OpenWRT link I posted above...
Tido Posted January 16, 2019 Posted January 16, 2019 sounded a bit outdated to me: As of Nov 10, 2015 the trunk version of OpenWrt does not boot...
Recommended Posts