Andre1000 Posted February 6, 2020 Share Posted February 6, 2020 Hello, I will use the integrated CAN-Controller with the actual version of Armbian Bionic (or Buster) on the BananaPi-M1 Actually it is not possible to activate the CAN-Bus. I had activate the CAN in the armbian-config. After a reboot I the CAN0 is not integrate in the list from "ifconfig -a". What are the steps to activate the CAN-Bus on the BananaPi M1. Many thanks, André Link to comment Share on other sites More sharing options...
Igor Posted February 6, 2020 Share Posted February 6, 2020 Providing logs with armbianmonitor -u significantly raises chances that issue is getting addressed. What do you have here: lsmod | grep can Link to comment Share on other sites More sharing options...
Andre1000 Posted February 7, 2020 Author Share Posted February 7, 2020 Hello, with "lsmod | grep can" I have no result. The log file is attached. André armbian-hardware-monitor.log Link to comment Share on other sites More sharing options...
Igor Posted February 7, 2020 Share Posted February 7, 2020 It seems you did the right things ... Module is enabled and it should be loaded after overlay is enabled. Try loading it manually perhaps? https://github.com/armbian/build/blob/master/config/kernel/linux-sunxi-current.config#L1540 ATM low of ideas why this doesn't work. Try legacy kernel - where people indeed reported success: armbian-config -> system -> alternative kernels and pick one with 4.19.y Link to comment Share on other sites More sharing options...
Andre1000 Posted February 8, 2020 Author Share Posted February 8, 2020 Thank you Igor, now the CAN-bus is available. André Link to comment Share on other sites More sharing options...
Igor Posted February 8, 2020 Share Posted February 8, 2020 1 hour ago, Andre1000 said: now the CAN-bus is available. 4.19.y or just loading a module? Link to comment Share on other sites More sharing options...
wollik Posted May 11, 2020 Share Posted May 11, 2020 On 2/6/2020 at 11:31 PM, Andre1000 said: Hello, I will use the integrated CAN-Controller with the actual version of Armbian Bionic (or Buster) on the BananaPi-M1 Actually it is not possible to activate the CAN-Bus. I had activate the CAN in the armbian-config. After a reboot I the CAN0 is not integrate in the list from "ifconfig -a". What are the steps to activate the CAN-Bus on the BananaPi M1. Many thanks, André Hi Andre1000, please can you share the diagram of the CAN interface you are using with the bananapi ? Link to comment Share on other sites More sharing options...
Recommended Posts