Zhexue. Posted January 18, 2023 Posted January 18, 2023 Hello all, I have installed the image "Armbian 23.02.0-trunk.0176 Lunar with bleeding edge Linux 6.1.6-bcm2711" on my two Raspi 4 systems. One system runs via cable and the other via WLAN. At the beginning there were some problems with the IPv6 - kernel, if "apt update" was executed. I got this problem under control with "disable ipv6".... Since then, both systems run flawlessly & without problems. With the implementation of GPIO you should fall back on an existing GPIO - version, which works in any case also under this image; also for 64bit. One small thing I would like to know very much, because on the system with the cable the WaveShare PoE - HAT is installed and I would like to monitor via software very much the FAN. Unfortunately, this does not work because the software does not see "I2C". In the Config - File, however, you see this as "enable" - What can I do here? Does anyone have an idea how I can enablen the I2C so that this works? Best regards from Germany..... Z. Matthias 0 Quote
wulfy23 Posted February 10, 2023 Posted February 10, 2023 i2c typically requires both config.txt entry and one or two supporting kernel modules to be loaded... When it comes to "daughter boards" and such, generally sticking to mainline / OEM roms is advised for anyone who is not out for a challenge... 0 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.