when booting Armbian Sid minimal rolling 6.1.11, there is no serial console login.
Console output:
Found U-Boot script /boot/boot.scr
1993 bytes read in 146 ms (12.7 KiB/s)
## Executing script at 12000000
93 bytes read in 94 ms (0 Bytes/s)
38318 bytes read in 2603 ms (13.7 KiB/s)
33621022 bytes read in 3482 ms (9.2 MiB/s)
11215360 bytes read in 1257 ms (8.5 MiB/s)
## Loading init Ramdisk from Legacy Image at 14800000 ...
Image Name: uInitrd
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 33620958 Bytes = 32.1 MiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
## Flattened Device Tree blob at 18000000
Booting using the fdt blob at 0x18000000
Using Device Tree in place at 18000000, end 1800c5ad
Starting kernel ...
Is there a way to enable console login to use the device headlessly?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
cvxx
Hi,
when booting Armbian Sid minimal rolling 6.1.11, there is no serial console login.
Console output:
Found U-Boot script /boot/boot.scr 1993 bytes read in 146 ms (12.7 KiB/s) ## Executing script at 12000000 93 bytes read in 94 ms (0 Bytes/s) 38318 bytes read in 2603 ms (13.7 KiB/s) 33621022 bytes read in 3482 ms (9.2 MiB/s) 11215360 bytes read in 1257 ms (8.5 MiB/s) ## Loading init Ramdisk from Legacy Image at 14800000 ... Image Name: uInitrd Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 33620958 Bytes = 32.1 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 18000000 Booting using the fdt blob at 0x18000000 Using Device Tree in place at 18000000, end 1800c5ad Starting kernel ...
Is there a way to enable console login to use the device headlessly?
Thanks
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.