Armbian Linux 6.6 (Ubuntu 24.04 Noble) Cubox server image doesn't boot

[monetschemist]

Greetings;

 

I have downloaded this https://dl.armbian.com/cubox-i/Noble_current_server and verified that I got what I was supposed to (ASC, SHA).

 

I have used a brand new usbimager to install it on various freshly formatted (brand new SD Formatter) and verified working Samsung Evo 32GB, SanDisk Extreme Plus 16GB, Extreme Plus 32GB.

 

All the formatting, imaging and installation done on an Ubuntu 25.04 laptop.

 

After usbimager is done, if I use the Ubuntu Disks application to look at the drive, the first partion shows as free space, which seems suspicious.

 

When I insert the newly-set up SD cards in the Cubox-i4, I see the bootloader start and then do its handoff to the operating system... and then nothing.  No more signal on the HDMI cable, nothing out on ssh, nothing.  The Cubox-i4 tries to reboot every few minutes with no more successful outcome.

 

This same Cubox-i4 runs fine with the last SD card system disk I built for it using the previous Debian server image.

 

Does anyone have any ideas?

 

Thanks in advance!

[laibsch]

unfortunately, we do not have a maintainer for this board, so it gets very little testing

[Igor]

https://paste.armbian.com/ehuwawexih

v25.5.1 image (Debian Bookworm minimal) runs on my Cubox i4, but HDMI out is untested ... images were released, only because I manage to spent some time testing and as I found out that build actually works.

 

[monetschemist]

Thanks for your replies!

 

@Igor is that screen shot you've pastebinned from a connection to the usb TTY?

 

I've ordered a new card reader / writer which should be here tomorrow.  The only one I currently have is in my elderly System76 laptop and I'm not fully confident in its driver support (for example it doesn't eject or unmount, so my only recourse is to run sync a bunch of times and then shut the machine down).

 

I don't think there's much point in building new cards with the Bookworm minimal version as that's what I currently have on my Cuboxes.

 

I will report back.  Thanks again!

[Igor]

2 hours ago, monetschemist said:

is that screen shot you've pastebinned from a connection to the usb TTY?

Connected via SSH. DHCP client is automatically getting IP, so you should be able to find the device on network after few minutes ... in case HDMI output is really broken. I can't test that as device is stashed to some rack.