cubieboard2 can boot only from 4.xx kernel !?


1 1

Recommended Posts

Hello, i have cubieboard2. This board boots and runs  successfully with Armbian-5.xx-Cubieboard-Debian(Ubuntu)-xx-4.xx.xx image, but i have NO success to boot

and run any Armbian_5.xx_Cubieboard2_Ubuntu_xenial_default_3.4.xxx_desktop.img image. Except, that i was able to boot and run Armbian_5.38_Cubieboard2_Ubuntu_xenial_default_3.4.113 image once and it worked for few hours, i was able to install some SW.  After power up  in the morning cb2 boots until kernel starts, show some flickering colorfull screen  and in a second red power led is off and board is not showing any progress. HDMI display says no signal.

Maybe someone has the same problem ? So to make it short: any kernel is loading and board is alive, any kernel hangs after Starting kernel.



Oleg K.

P.S. added log file, will try to get some info



found same problem in


Link to post
Share on other sites

Donate and support the project!

This topic is now closed to further replies.

1 1