Igor's odroid N2 image works...
Here are dmesg red lines that require investigation from somebody more expert than me:
clkmsr ffd18004.meson_clk_msr: failed to get msr ring reg0
cvbs_out: chrdev devno 263192576 for disp
dmi: Firmware registration failed.
perf_event: read sys_cpu_status0_offset failed, ret = -22
meson-pwm ff802000.pwm: pwm pinmux : can't get pinctrl
meson-pwm ffd1b000.pwm: pwm pinmux : can't get pinctrl
mtdoops: mtd device (mtddev=name/number) must be supplied
drivers/amlogic/efuse/efuse_hw64.c:_efuse_read:196: read error!!!
meson_cpufreq_probe: Registered platform drive
[ 2.063911] ff803000.serial: clock gate not found
gpio-keypad ff800000.gpio_keypad: failed to get gpio index from dts
efuse efuse: open efuse clk gate error!!
di_get_vpu_clkb: get clk vpu error.
PPMGRDRV: err: ppmgr_driver_probe called
[ 2.199532] Reserved memory: failed to init DMA memory pool at 0x00000000e3000000, size 0 MiB
[ 2.202554] meson-mmc: mmc driver version: 3.02, 2017-05-15: New Emmc Host Controller
[ 2.203254] meson-mmc: >>>>>>>>hostbase ffffff8008629000, dmode
[ 2.242335] meson-mmc: meson_mmc_probe() : success!
[ 2.249480] meson-mmc: >>>>>>>>hostbase ffffff8008632000, dmode
[ 2.249515] meson-mmc: gpio_cd = 1ca
[ 2.252739] meson-mmc: emmc: resp_timeout,vstat:0xa1ff2800,virqc:3fff
[ 2.252742] meson-mmc: emmc: err: wait for irq service, bus_fsm:0x8
[ 2.252759] meson-mmc: meson_mmc_irq_thread_v3 551 emmc: cmd:1
[ 2.252761] meson-mmc: meson_mmc_irq_thread_v3() 567: set 1st retry!
[ 2.252763] meson-mmc: retry cmd 1 the 3-th time(s)
[ 2.253757] meson-mmc: emmc: resp_timeout,vstat:0x9dff0800,virqc:3fff
[ 2.253759] meson-mmc: emmc: err: wait for desc write back, bus_fsm:0x7
[ 2.253765] meson-mmc: meson_mmc_irq_thread_v3 551 emmc: cmd:1
[ 2.253766] meson-mmc: retry cmd 1 the 2-th time(s)
[ 2.254757] meson-mmc: emmc: resp_timeout,vstat:0x9dff0800,virqc:3fff
[ 2.254759] meson-mmc: emmc: err: wait for desc write back, bus_fsm:0x7
[ 2.254765] meson-mmc: meson_mmc_irq_thread_v3 551 emmc: cmd:1
[ 2.254766] meson-mmc: retry cmd 1 the 1-th time(s)
[ 2.255757] meson-mmc: emmc: resp_timeout,vstat:0x9dff0800,virqc:3fff
[ 2.255759] meson-mmc: emmc: err: wait for desc write back, bus_fsm:0x7
[ 2.255764] meson-mmc: meson_mmc_irq_thread_v3 551 emmc: cmd:1
[ 2.255767] meson-mmc: Command retried failed line:585, cmd:1
[ 2.286325] meson-mmc: meson_mmc_probe() : success!
[ 2.286490] amlogic mtd driver init
[ 2.287074] cectx ff80023c.aocec: cec driver date:Ver 2019/1/7
[ 2.287548] cectx ff80023c.aocec: not find 'port_num'
[ 2.287551] cectx ff80023c.aocec: using cec:1
[ 2.287580] cectx ff80023c.aocec: no hdmirx regs
[ 2.287582] cectx ff80023c.aocec: no hhi regs
[ 2.287586] cectx ff80023c.aocec: not find 'output'
[ 2.287591] cec: wake up flag:0
[ 2.289030] cectx ff80023c.aocec: irq cnt:2
[ 2.289243] cectx ff80023c.aocec: wakeup_reason:0x0
[ 2.289289] cectx ff80023c.aocec: cev val1: 0x0;val2: 0x0
[ 2.289292] cectx ff80023c.aocec: aml_cec_probe success end
defendkey ff630218.defendkey: Reserved memory is not enough!
aml_card_probe error ret:-517
cgroup: cgroup2: unknown option "nsdelegate"
meson-mmc: Tuning transfer error: nmatch=0 tuning_err:0xffffffac
Error: Driver 'spdif-dit' is already registered, aborting...
[ 2.323264] asoc debug: aml_audio_controller_probe-115
[ 2.324305] aml_card_probe error ret:-517
Proof of work and complete dmesg is attached below
dmesg