Fix a damage SD card

Recommended Posts

Armbian is a community driven open source project. Do you like to contribute your code?

If you're inexperienced maybe the best idea is to simply follow the 'Getting started' guide step by step:


(so prior to flashing with Etcher always testing the SD card first with F3 or H2testw and in case this is an SD card that was already in use you might want to reset it to 'factory performance' with 'SD Formatter' in the next step still prior to flashing with Etcher -- everything explained in the link above)

Link to post
Share on other sites

There are many ways to fix a damage SD card. I often use the command prompt and rename these two methods. Here are the steps:
Use a command prompt:
Connect the damaged SD card to your computer > Go to "My Computer" > Under the "Devices and Drives" section, locate the SD card and write down its drive letter > Run the command prompt and type "chkdsk h:/ r", Where "h" is the letter of the drive > check if the problem has been successfully resolved.

Open Disk Management > Find SD Card > Right click and select "Change drive letter and path" > Apply changes > Reboot the system and connect the SD card again > Check the SD card.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.