Ozebe Posted September 23, 2017 Posted September 23, 2017 Hi everyone, have any of you ever used the orange pi GPIO inputs to use as SATA inputs, so you can use HD's? if so, what procedure to take?
martinayotte Posted September 23, 2017 Posted September 23, 2017 What is the relation between GPIO and SATA ? None !
lanefu Posted September 23, 2017 Posted September 23, 2017 look at the sata inputAlthough it does look like GPIO at a glance, It's actually usb-based SATA. The NAS board connects to some additional USB ports the orange pi zero has broken out in a separate pin header. Sent from my SM-G950U using Tapatalk
martinayotte Posted September 23, 2017 Posted September 23, 2017 Right ! Header pins are not necessarily GPIOs, in this case, it is really two additional USB provided on pins 3 to 6.
Ozebe Posted September 23, 2017 Author Posted September 23, 2017 Do you think this module works to use a hard drive with the orange pi?
martinayotte Posted September 23, 2017 Posted September 23, 2017 Of course ! But you also need +5V/+12V Power Supply.
Ozebe Posted September 23, 2017 Author Posted September 23, 2017 thanks, I will use my old computer source to power the molex cable.
martinayotte Posted September 23, 2017 Posted September 23, 2017 Next time you need another, some of the kits provides the PSU : http://www.ebay.ca/itm/SATA-PATA-IDE-to-USB-2-0-Adapter-Converter-Cable-for-2-5-3-5-Inch-Hard-Drive-IN-/311837844163
Recommended Posts