balbes150

New image ver 5.82 S9xxx and Odroid N2

For the analysis, you need the output of the "printenv" "help" commands from the UART console.

Update image ver 5.82 Kernel NEXT (5.1.0-rc6) works HDMI.

New image Armbian 5.82 and Libreelec 20190427.

any 5.78 (setup use dtb for x96max)

https://forum.freaktab.com/forum/main-category/main-forum/770129-rk3588-8k-arm-cortex-a76-a55-soc-rockchip-roadmap-to-2020

All DTBS from Android are designed strictly for the old kernel. They will not work directly on core 5. From your files, you can only get the primary information to create an option for your model. But this is not an easy task that requires a lot of manual work.

RK3399 is a much more powerful device.

Good news. I checked the work Armbian on the model Beelink GT1 mini (S905X2). The system starts normally with dtb from x96max, works wired network, HDMI, BT, eMMC, SD and USB.

This is not the X96 max, this is a different model. Maybe it need other option DTB, with other settings for eMMC.

Kernel N2 for Armbian is the result of joint work BayLibre and developer community Libreelec (we work together closely). It takes time for everything to look finished. Only then will the publication.

Show photos of your model and SATA connector. I just checked image 20190412 on my X96Max (S905X2) 4\32. eMMC without problems visible, works utility DDBR (allows you to create and restore full backup eMMc) and installation works Armbian in eMMC.

Sound through HDMI and the rest is there , but it is WIP and not yet for public use.

On X96 max there are no SATA devices.

Have you seen the information that this model is supported ? Armbian has nothing to do with coreelec. These systems are incompatible.

This is the primary version (alpha) there is still a lot of it does not work as needed.

Update image ver 5.78

Images Armbian for N2 is already there and tested, you can freely use. https://forum.armbian.com/topic/7930-armbian-for-amlogic-s9xxx-kernel-41x-ver-555/?do=findComment&comment=76997

x96mini -> WiFi ssv6051 -> You can forget about it, the chip manufacturer has long disappeared and no one will make a driver for it

https://forum.libreelec.tv/thread/12330-test-libreelec-images-with-kodi-18-for-s9xxx/?postID=115543#post115543

Issues firmware Android looking forum Freacktab, there is a lot of information. You may need to use a different USB port, or a different order of steps for your model. use nodm

Settings->Display

Pay attention. To properly boot the system to SD card on Odroid N2 you need to switch the startup u-boot was installed on SD\eMMC. (that is, the position that is used in the release of equipment from the plant).

Implementation of protection can be different. The General principle is to avoid performance degradation, keep the system at a temperature knowingly below the point of limitation. For rk33xx I recommend not to exceed 70 degrees. It is desirable at any loads to have a temperature of not more than 20-30 degrees, relative to the environment. This ensures minimal problems with thermal expansion (metals and PCB have different thermal expansion coefficients). The smaller the temperature difference during operation and shutdown, the less problems with operation.

This file is now part of the image.