Jump to content

forcte to connect to wifi


Recommended Posts


i use armbian on my orange pi and have a problem about the wifi connection.


I have my orange pi near my 3D printer.

When i plug it in, to boot the armbian it works great. But the orange pi will (SOMETIMES) not connect to my wlan. 

When i change the room and put it nearly my pc, it will connect without any problems...


So i check the wifi quality:


 - near my pc i have a link quality 70/70

 - near my 3d printer i have a link quality 64/70 and signal level: 46dBm


is this to low for a easy connection??

thank you


Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

Terms of Use - Privacy Policy - Guidelines