Getting error installing Octoprint via armbian-config on Orange Pi Zero

[seamoce]

Hi,

I installed on my Orange Pi Zero (not plus) armbian and using armbian-config I am trying to install Octoprint to control my 3d printer. 

I got an error:
 

docker: Error response from daemon: error gathering device information while adding custom device "/dev/video0": no such file or directory

I have no webcam attached and I am not planning to use it for now, Can I disable this check?
 

[Werner]

moved

 

Providing logs with 

armbianmonitor -u

 helps with troubleshooting and significantly raises chances that issue gets addressed.

[robertoj]

Make sure that the octoprint project still supports 32 bit CPUs

 

For low ram sbc's, I suggest doing a classic installation, instead of Docker

 

You can skip the webcam portion installation, and give you no problems.

 

I had my opiz LTS (512MB) running octoprint last year, and the webcam function works well... but I only used octoprint-Docker when I had 2GB of RAM server.

[seamoce]

@Werner https://paste.armbian.com/izobaqaguk here the link

 So do you think docker cannot run well on this device?

[robertoj]

I think it will run out or RAM... but try it anyway

[djurny]

Hi there,

I ran octoprint and klipper on a orangepi zero (not at the same time). Octoprint from docker and klipper I cannot remember.

Octoprint ran fine but it did have some issues when the CPU got overloaded with loading a new gcode file while printing for example. If you do things one by one it should be OKish. 

Btw i ran octoprint in a 512MB version, not on the 256MB one.

Groetjes,