I installed Armbian_5.59_Cubox-i_Debian_stretch_next_4.14.66 on my Cubox-i.
Boots nicely, but ethernet is not working. The ethernet cable/connection is working, because the cable does work via and ethernet-to-usb connector to the same cubox. EDIT: Oh, I must say that ethernet-to-usb is fast etnernet, not GigE /EDIT
Dmesg included. Plus dmesg | grep network stuff.
Tips how to proceed?
root@cubox:~# cat dmesg.cubox.no-eth.txt | grep -i -e eth -e netw
[ 0.793426] fec 2188000.ethernet: 2188000.ethernet supply phy not found, using dummy regulator
[ 0.806213] fec 2188000.ethernet eth0: registered PHC device 0
[ 10.900568] Atheros 8035 ethernet 2188000.ethernet-1:00: attached PHY driver [Atheros 8035 ethernet] (mii_bus:phy_addr=2188000.ethernet-1:00, irq=POLL)
[ 10.900651] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 13.984996] fec 2188000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx
[ 13.985019] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Question
Superkoning
I installed Armbian_5.59_Cubox-i_Debian_stretch_next_4.14.66 on my Cubox-i.
Boots nicely, but ethernet is not working. The ethernet cable/connection is working, because the cable does work via and ethernet-to-usb connector to the same cubox. EDIT: Oh, I must say that ethernet-to-usb is fast etnernet, not GigE /EDIT
Dmesg included. Plus dmesg | grep network stuff.
Tips how to proceed?
root@cubox:~# cat dmesg.cubox.no-eth.txt | grep -i -e eth -e netw [ 0.793426] fec 2188000.ethernet: 2188000.ethernet supply phy not found, using dummy regulator [ 0.806213] fec 2188000.ethernet eth0: registered PHC device 0 [ 10.900568] Atheros 8035 ethernet 2188000.ethernet-1:00: attached PHY driver [Atheros 8035 ethernet] (mii_bus:phy_addr=2188000.ethernet-1:00, irq=POLL) [ 10.900651] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 13.984996] fec 2188000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx [ 13.985019] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
dmesg.cubox.no-eth.txt
Link to comment
Share on other sites
14 answers to this question
Recommended Posts